Stick radius - Revision history

Bell: 7 revisions

2014-03-28T03:36:14Z

7 revisions

Ykalidas: /* If the above commands do not work */

2009-09-02T06:00:27Z

If the above commands do not work

Ykalidas: /* Syntax */

2009-08-31T04:11:11Z

Syntax

New page

==Overview==
This setting affects the radius of sticks in the sticks representation. Default scale is set to 0.25.

In newer versions of PyMOL, one may set the [[Stick_radius]] on a per-bond basis. So, you can set for example, the radius of only selected bonds if you want. This is done through the [[Set_bond]] command.

<gallery>
Image:Stick_rad_0.05.png|stick_radius set to 0.05
Image:Stick_radius_default.png|stick_radius set to the default 0.25
Image:Stick_rad_0.85.png|stick_radius set to 0.85
</gallery>

==Syntax==
<source lang="python">
set_bond stick_radius, ''size'', selection
</source>
where,
*''size'' can be any float number. Using 0.25 (default value) is usually appropriate for most representations, although 0.15 migh be preferred for comparing closely related structures, e.g., conformers.

''Note:'' <source lang="python">set_bond stick_radius</source> by itself will revert to 1.00.
==If the above commands do not work==
You can do something like below
<source lang="python">
set stick_radius=0.12
</source>

==Related settings==
*[[Set_bond]]
*[[sphere_scale]]
*[[stick_ball_ratio]]

[[Category:Sticks]]
[[Category:Settings]]

Ojganesh: /* Syntax */

2008-04-28T17:00:35Z

Syntax

Ojganesh: /* Syntax */

2008-04-28T17:00:24Z

Syntax

Pablo.englebienne: created initial description, based on sphere_scale

2007-02-07T18:43:29Z

created initial description, based on sphere_scale

New page

==Overview==

This setting affects the radius of sticks in the sticks representation. Default scale is set to 0.25.

==Syntax==

<code>set sticks_radius, ''size''</code>

''size'' can be any float number. Using 0.25 (default value) is usually appropriate for most representations, although 0.15 migh be preferred for comparing closely related structures, e.g., conformers.

''Note:'' <code>set stick_radius</code> by itself will revert to 1.00.

==Related settings==

*[[sphere_scale]]
*[[stick_ball_ratio]]

@@ Line 5: / Line 5: @@
 ==Syntax==
-<code>set sticks_radiu, ''size'', selection</code>
+<code>set stick_radius, ''size'', selection</code>
 ''size'' can be any float number. Using 0.25 (default value) is usually appropriate for most representations, although 0.15 migh be preferred for comparing closely related structures, e.g., conformers.

← Older revision	Revision as of 03:36, 28 March 2014
(No difference)

@@ Line 21: / Line 21: @@
 You can do something like below
 <source lang="python">
 set stick_radius=0.12
 </source>